Astm d1238 pdf free download
Download Astm-d Type: PDF. Date: September Size: KB. Author: CarlosGrimaldi. This document was uploaded by user and they confirmed that they have the permission to share it. If you are author or own the copyright of this book, please report to us by using this DMCA report form. Download Free PDF. Download Free PDF. D − 13 Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer1 This standard is issued under the fixed designation D; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision Estimated Reading Time: 16 mins. · Astm D Pdf Free PDF eBooks. This standard is issued under the fixed designation D ; the number 1 This test method is under the jurisdiction of ASTM Committee D20 on Plastics. ASTM D (Procedure A), D Plastic Centre of Excellence.
ASTM D, Edition, July 1, - Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer. This test method covers the determination of the rate of extrusion of molten thermoplastic resins using an extrusion plastometer. The values stated in SI units are to be regarded as standard. Annual Book of ASTM Standards, Vol combined residual chlorine, n-residual consisting of chlorine combined with ammonia nitrogen or nitrogenous compounds. free available chlorine residual, n-residual con sisting of hypochlorite ions, hypochlorous acid, or a combi nation thereof. cause failure of the specimen. Free-end closures shall be used for referee tests for thermoplastic pipe. NOTE 4—Free-end closures fasten to the specimen so that internal pressure produces longitudinal tensile stress in addition to hoop. Com-pared to free end closure specimens, stresses in the wall of restrained-end.
cause failure of the specimen. Free-end closures shall be used for referee tests for thermoplastic pipe. NOTE 4—Free-end closures fasten to the specimen so that internal pressure produces longitudinal tensile stress in addition to hoop. Com-pared to free end closure specimens, stresses in the wall of restrained-end. approved in Last previous edition approved in as D - 04c. DOI: /D 2 For referenced ASTM standards, visit the ASTM website, bltadwin.ru, or contact ASTM Customer Service at service@bltadwin.ru For Annual Book of ASTM Standards volume information, refer to the standard’s Document Summary page on the ASTM website. 1. [2] ASTM D, , " Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer, " Annual Book of ASTM Standards, Vol. , ASTM International, West Conshohocken.
0コメント